How to Install Windows 8/7 from a USB Drive

 

How to Install Windows 8/7 from a USB Drive …………. 

 Installing Windows from a USB flash drive has several advantages – First of all, the overall speed of the installation process will increase significantly, carrying a USB stick is much more convenient than a DVD, and finally it becomes possible to install the OS even on those systems that do not have a DVD drive, such as a netbook. Here, I will show you how to load the Windows installation on to your USB flash drive and make it bootable just like the DVD.

Tools Required:

1. USB flash drive with a minimum capacity of 4 GB.
2. Windows 8 set-up DVD.
Now, just follow the below steps:

Step-1:

• Plug-in your USB flash drive and backup all the existing data in it. 
• Open the command prompt. If you are using Windows 8/7/Vista then open it with administrator rights.
•  i.e.: Go to Start -> All Programs -> Accessories -> Right-click on “Command Prompt” and select 

• “Run as Administrator”.

Step-2:

In the command prompt, type in the following command:

 DISKPART 

This will start the Microsoft DiskPart utility as shown below:

Step-3:

Now issue the following command:

 LIST DISK

 This will show you a list of available disks on your system. Disk 0 is usually the hard disk. In my case, Disk 5 is the USB drive (this can be a different one in your case). Now issue the command as shown below:

SELECT DISK 5

NOTE: 

 In the above command, 5 is the USB drive number on my system. If you have a different number on your system, then you need to replace 5 with that number.

Step-4:

Now issue the following list of commands one by one as shown below:

CLEAN

CREATE PARTITION PRIMARY

SELECT PARTITION 1

ACTIVE

FORMAT FS=NTFS QUICK

 ASSIGN

 EXIT

Minimize the command prompt and proceed to the next step.

Step 5:

Insert the Windows 7/Vista installation disc and note down the “drive letter” of your DVD drive. In my case, it is “H:” Now type the following list of commands as shown below:

H: CD BOOT

 CD BOOT

 BOOTSECT.EXE /NT60 M: (NOTE: M: is your USB drive letter)

 EXIT

Step-6:

Copy the contents of your Windows 8/7/Vista installation disk into the USB flash drive. Make sure everything has copied or the set up will not progress…

That’s it! Your USB stick is now ready to boot and install the OS for you. Don’t forget to enable the “USB Boot” option and change the “boot priority to USB device from hard disk” in your BIOS settings.

Main thing is that you can use it on other computers. In case you need the USB drive, just erase the files in it. After when u want to run installation again just copy the files again. The installation process take only about 10-15 mins.